Back-Up

Installing A Wireless Rear View Car Back-Up Camera

Rear View Car Back-Up Camera Systems can be either cabled or wireless, depending on the model (The Camera not the car!).  The Wireless option can be very simple to install.

 

Installing a Wireless Monitor & Rear View Back-Up Camera System for your car

 

In the example video below we are installing a Back-Up Camera System, Model ACA250, which is a Wireless monitor and rear view camera system for backing up your car, but the same steps are commonly used for most Back-Up Camera Systems.

Installing a Wireless Colour Monitor & Back-Up Camera System

 

How to install a Wireless Backup Camera with monitor: 

Car Camera, Monitor and Power Source

1.   Take off your license plate at the back of your car.

2.   Remove the car’s Reverse Tail Light so as to access the backup lamp wires.

3.   Connect the camera’s power leads to the reverse light of your car to get the power – red wire for positive and black wire for negative.

4.   Connect the power cable leads running from the Reverse Light, or ‘tail light’ to your camera, via the trunk to behind  the License Plate.

5.   Put back the Tail light and the License Plate.

6.   Fix the camera’s bracket to the license plate where the bottom two screws are situated, using those screw holes to fix it in.

7.   Position the Monitor on the front dashboard of the car or wherever you decide to put it, making sure that it will not block your view while driving.
See More…“Installing A Wireless Rear View Car Back-Up Camera” »

ItsHere4u.info 2024